Filter
Top Products
Administrator’s Guide and Operating Instructions
27
Recording Quality For All Cameras – The range is 0-10, with 0 the
lowest (rough) quality, 10 the highest (fine) quality. The default
value is 5 . Use the Up/Down arrow buttons to adjust the value.
Compression Method For All Cameras – MPEG (MPEG-1) or
JPEG-CIF (JPEG), resolution – 352x240 for NTSC, 352x288 for
PAL.
Enable Digital Watermark – Check to enable digital watermark. The
system provides up to 64 positions to locate the digital watermark.
Click on the Vertical Position and Horizontal Position items to select
the desired location. For the vertical position, the number 0 ~ 7
is from up to down, for the horizontal position, the number 0 ~ 7 is
from left to right.
Enable Motion Detection – Check to enable motion detection for the
selected Camera at the selected Time Type.
Motion Action – The corresponding Motion Action if motion
detection enabled.
Video Loss Action – The corresponding Video Loss Action (always
enabled).
Normal Record (FPS) – The normal recording rate for the selected
Camera at the selected Time Type. Use the Up/Down arrow buttons
to adjust the value (0-30). The default value is 0.1 Frame Per Second
(or 6 Frame Per Minute). (Note)
Alarm Record (FPS) – The alarm-recording rate for the selected
Camera at the selected Time Type. Use the Up/Down arrow buttons
to adjust the value (0-30). The default value is 5 Frame Per Second
(or 300 Frame Per Minute).
Note 1 : The minimum recording rate for the system is 0.1 FPS. If the total
recording rate for all cameras is less than 0.1 FPS, the system will increase the
recording rate for each camera averagely to make the total 0.1 FPS. On the
other hand, the maximum recording rate for the system is 25/50 FPS for
PAL, 30/60 FPS for NTSC (1xFPS/2xFPS). If the total recording rate for all
cameras is greater than 25/50 (30/60) FPS, the system will decrease the
recording rate for each camera averagely to make the total 25/50 (30/60) FPS.
Note 2 : The remote end will not be able to view all the camera windows if there’s any
camera is set as 0 FPS for the normal recording rate; unless all the cameras are
set as 0 FPS.