Filter
Top Products
20
NS-24LD100A13 Insignia 24" LCD TV/DVD Combo
www.insigniaproducts.com
B. If you select Cable, a message asks if you have
a cable box.
• Select No if no cable box is connected.
Your TV scans for available channels. The
scan may take several minutes.
• Select Yes if a cable box is connected. A
message asks how you connected the
cable box to your TV.
• Select AV, Component, or HDMI if you
connected a cable box to your TV using
one of these cables. Read the message,
then press OK to close the wizard.
• Select Coaxial if you connected a cable
box to your TV using a coaxial cable.
Read the message, then press OK to
start the channel scan (VHF channels
only).
C. If you select Satellite Box, a message asks
how you connected the satellite box to your
TV.
• Select AV, Component, or HDMI if you
connected a satellite box to your TV using
one of these cables. Read the message,
then press OK to close the wizard.
• Select Coaxial if you connected a satellite
box to your TV using a coaxial cable. Read
the message, then press OK to start the
channel scan (VHF channels only).
12 To watch TV, press INPUT, press
or to
highlight the video input source for your
TV/DVD combo in the INPUT SOURCE list, then
press OK.
• If your TV/DVD combo is connected to an
antenna, cable TV (no box), or cable or satellite
TV box using a coaxial cable, select TV.
• If your TV/DVD combo is connected to a cable
or satellite box using an HDMI cable or HDMI
cable with a DVI adapter, select HDMI 1 or
HDMI 2.
• If your TV/DVD combo is connected to a cable
or satellite box using a component video
cable, select Component.
• If your TV/DVD combo is connected to a cable
or satellite box using a composite video cable,
select AV.
Understanding the basics
Turning your TV/DVD combo on or off
To turn your TV/DVD combo on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV/DVD combo.
The power indicator turns blue.
3 Press (power) again to turn off your TV/DVD
combo. Your TV/DVD combo enters standby
mode, and the power indicator LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV/DVD combo, then press INPUT.
The INPUT SOURCE list opens.
2 Press
or to select a video input source, then
press OK.
Do you have a Cable Box?
No
Yes
Move
OK
ENTER
MENU
EXIT
Exit
Previous
Select
How did you connect the
AV, Component, or HDMI
Coaxial
Move
OK
ENTER
MEN U
EXIT
Exit
Previous
Select
cable box to the TV?
How did you connect the
AV, Component, or HDMI
Coaxial
Move
OK
ENTER
MEN U
EXIT
Exit
Previous
Select
satellite box to the TV?
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
Warning
When your TV/DVD combo is in standby mode, it is
still receiving power. To completely disconnect
power, unplug the power cord.
Note
If your TV/DVD combo does not receive an input
signal for several minutes, it automatically goes into
standby mode.
TV
AV
HDMI 1
DVD
HDMI 2
USB
INPUT SOURCE
Component
VGA
NS-24LD100A13_12-0375_MAN_V1_ENG.book Page 20 Wednesday, September 19, 2012 12:46 PM