Filter
Top Products
Filename [MV4S_12RemoSys.fm]
Masterpage:Left0
68 EN
Page 68 Monday, 9 May 2005 09:42
REMOTE CONTROL
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four codes
(1, 2, 3 or 4). The remote control is preset to send 3 code signals
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
● Keep pressing SET UP down during step 1.
1 Press the number button “1” for 1, “2” for 2, “3” for 3 or “4”
for 4 to change the remote control code, then press ENTER.
2 Press 1 on the unit to turn off the unit.
3 Press 4 on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4 Press 8 on the remote control to change the unit’s code. The
code currently set on the remote control blinks on the front display
panel for approximately 5 seconds, and is applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (੬ pg. 71), it is not possible to
change the remote code.
Controlling your TV (only for JVC TVs)
The remote control can operate your JVC TV. Turning power on/off,
changing input mode, selecting channel and volume setting are
possible. Other manufacturer’s TVs cannot be operated by this
remote control.
Remote Control Functions
ENTER
SET UP
1 – 4
VHS/DVD
DVDVHS
REC
VHS DVDDUBBING
CH
STANDBY/ON
S-VIDEO VIDEO AUDIO
TV CH +/–
TV VOL +/–
TV INPUT
MV4S_12RemoSys.fm Page 68 Monday, May 9, 2005 9:42 AM