JVC DR-MV4SUJ DVD VCR Combo User Manual


 
Masterpage:Right0
EN 69
Filename [MV4S_12RemoSys.fm]
Page 69 Monday, 9 May 2005 09:42
SYSTEM CONNECTIONS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1 Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using an optional coaxial cable.
NOTES:
For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (pg. 70)
For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
(pg. 70)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not supplied)
Rear of unit
To [DIGITAL AUDIO
OUT (COAXIAL)]
MV4S_12RemoSys.fm Page 69 Monday, May 9, 2005 9:42 AM