Filter
Top Products
Filename [MV4S_13Subsidiary.fm]
Masterpage:Left+
72 EN
SUBSIDIARY SETTINGS
Page 72Monday, 9 May 2005 09:42
OTHERS
8 RESUME — OFF / ON / DISC RESUME
When this function is set to “ON” or “DISC RESUME”, you can use
the resume function. (੬ pg. 44)
OFF: You cannot use the resume function.
ON: You can start playback from the resume point of the placed
disc.
DISC RESUME: The unit retains a memory of the resume points of
the last 30 discs played back, even though they have been ejected.
NOTE:
“DISC RESUME” setting works on DVD VIDEO, VCD and already
finalized DVD-R/DVD-RW (video mode) discs. For other types of discs,
the function under “ON” setting will be applied even if “RESUME” is set
to “DISC RESUME”.
8 AUTO POWER OFF — OFF / 3H
When this function is set to “3H”, the unit is turned off automatically
if no operation is done within 3 hours.
If you connect the unit and TV with Component Video Connection
(੬ pg. 18), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction of
higher-quality images.
8 Interlaced scan
In the conventional video system, a picture is shown on the display
monitor in two halves. The Interlaced scan system places lines of
the second half of the picture in-between lines of the first half of the
picture.
8 Progressive scan
Progressive scan displays all the horizontal lines of a picture at one
time, as a single frame. This system can convert the interlaced
video from DVD into progressive format for connection to a
progressive display. It dramatically increases the vertical
resolution.
1 Press DVD so that the DVD lamp lights up on the unit.
2 Press PROGRESSIVE SCAN for 3 or more seconds.
● Video output indicator ( ) lights on the front display panel if
Progressive scan mode has been established. (੬ pg. 13)
● Each press of PROGRESSIVE SCAN for 3 or more seconds
switches the scan mode.
NOTES:
● Interlaced scan mode is the setting at your purchase.
● Interlaced scan mode might be suitable depending on video material.
● Scan mode cannot be set while menu screen is displayed.
● When the Progressive scan mode is engaged, no video signal is
output from [S VIDEO OUTPUT] connector and [VIDEO/AUDIO
OUTPUT] connectors.
Scan Mode Set
A
TTENTION:
● Your TV needs to be compatible with Progressive.
● Make sure that there is no disc in the unit.
● Turn on the unit.
● Turn on the TV and select the AV mode.
Watch the images on VHS deck in the Progressive scan
mode via component video
1 Set the Progressive-compatible TV to the component input
mode.
2 Press DVD so that the DVD lamp lights up on the unit.
3 Press PROGRESSIVE SCAN for 3 or more seconds.
● The video output indicator lights up on the front display panel.
4 Press VHS so that the VHS lamp lights up on the unit, then
press PROGRESSIVE SCAN.
● “]” lights up on the unit.
NOTES:
● Be sure to engage the DVD deck in stop mode.
● During still picture in VHS Progressive Scan mode, the images
may jitter, but this is not a malfunction.
DVD
VHS
PROGRESSIVE
SCAN
MV4S_13Subsidiary.fm Page 72 Monday, May 9, 2005 9:42 AM