Filter
Top Products
Masterpage:Right-No-Heading
EN 91
Filename [DR-M10SE_10Editing.fm]
Page 91 February 13, 2004 2:22 pm
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
Make connections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to
“DOLBY DIGITAL/PCM”. (
੬ pg. 93)
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/
PCM”. (
੬ pg. 93)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.
Back of unit
Note for connection:
Remove the protection
cap from the optical
cable.
Optical cable
(not provided)
Dolby Digital
decoder or amplifier
with built-in DTS
To DIGITAL AUDIO
input
Coaxial cable
(not provided)
DIGITAL OUT
(OPTICAL)
DIGITAL OUT
(COAXIAL)
When you can’t switch the audio channel of a
bilingual programme
When the unit is connected with a digital audio device using
an optional optical cable and “DIGITAL AUDIO OUT” is set
to “DOLBY DIGITAL/PCM”, it is not possible to switch the
audio channel of a bilingual programme recorded on a
DVD-RAM or DVD-RW (VR mode) disc. In this case, perform
the following steps using the remote control to switch
“DIGITAL AUDIO OUT” from “DOLBY DIGITAL/PCM” to
“PCM ONLY”.
A Press SET UP to access the Main Menu screen.
B Press we to select “DVD SET UP”, then press ENTER.
C Press we to select “AUDIO OUTPUT”, then press
ENTER.
D Press rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
E Press rt to select “PCM ONLY”, then press ENTER.
(
੬ pg. 93)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.
(
੬ pg. 34, “Audio Channel Selection”)
DR-M10SE_10Editing.fm Page 91 Friday, February 13, 2004 2:22 PM