Filter
Top Products
33
SAT
LOCATING SATELLITES
The function allows you to search for satellites whose
transponder frequencies are unknown. The frequency range from
1000 to 2100 MHz is continuously scanned for reception signals.
If a reception signal is detected, the reception level is indicated
in the display in the form of an increasing or decreasing bar.
The
buttons allow you to set the measurement
range to three sensitivity levels.
A bearing sound enables you to monitor the level. The pitch
of the bearing sound is proportional to the received signal
level. The volume of the bearing sound can be adjusted using
the
volume buttons.
Command overview
Switch to the “frequency-independent satellite
search” mode.
Switch the measurement range, the bar graph and
the bearing sound:
Level range 1: Large input levels
Level range 2: Medium input levels
Level range 3: Small input levels
Exit this mode
LC display:
• Level range 2: Medium input level
• SAT mode
• Bar graph display with bearing sound
Example
Launching the “Find satellite” function:
• Press the
button.
• Slowly turn the antenna until a level tendency can be seen on the
bar display
• Slowly turn the antenna until the bar display reaches its
maximum
• If necessary, decrease or increase the sensitivity using the
and buttons
• Press the
button to exit this function