Filter
Top Products
60
STORING MEASUREMENT RESULTS
STORING MEASUREMENT RESULTS IN THE DEVICE MEMORY
First select the measuring job and perform the measurement!
The Memory Explorer command displays the
stored measuring results on the TFT display.
Use the Up and Down buttons to go a page up
or down in the screen content.
Opens the entry fi eld on the LC display to determine
a storage place for the new measurement
result.
... Enter storage place 00 ... 99.
From 00 to 99 every measurement can be stored
individually.
Complete - the measurement results have been
stored in the device.
Up to 10 spectrum images can be stored. You can select any
storage place (storage number) of your choice. If you try to store
more than 10 spectrum images, the following message will be
displayed:
Spectrum Memory Full!
Only 10 Spec. Possible
You then need to delete at least 1 spectrum storage place
(see next page).
TFT display
LC display
Note
RECOVERING MEASUREMENT RESULTS FROM THE DEVICE MEMORY
The Memory Explorer command displays the
stored measuring results on the TFT display.
Use the Up and Down buttons to go a page up
or down in the screen content.
Opens the entry fi eld on the LC display for entry
of the storage place where the measurement
results are to be retrieved.
... Enter storage place 00 ... 99.
From 00 to 99 any storage place can be called
up.
The measurement results are indicated on the TFT
display (example: measurement result no.: 02).
TFT display
LC display
394.00 MHz CABLE D