Filter
Top Products
3. Disconnect the skew motor cable from the PCB
module.
4. Remove the four #8-32 screws securing the
LNB/feed tube assembly to the reflector base (see
Figure 5-34). Withdraw the LNB/feed tube
assembly through the center hole in the reflector.
5. Disconnect the motor cable from the skew motor.
6. Using a 2.5 mm allen wrench, remove the four M3
cap screws and #4 washers securing the motor to
the LNB/feed tube assembly (see Figure 5-35).
Remove the old skew motor.
54-0198
114
TracVision G8 Owner’s Manual - Guide to Technical Information
POWER
ELEVATION GYROINTERNAL SENSOR SKEW MOTOR
ELEVATION & AZIMUTH MOTORS
AZIMUTH/ROLL GYROLIMIT SWITCHES
FUSE
Skew Motor
Cable Connector
Figure 5-33
Skew Motor Cable Connector
on PCB Module
Pulley
Motor Hub
Figure 5-35
Skew Motor and Belt
M3 Cap Screws
and #4 Washers
(x 4)
Motor Cable
Connector
Figure 5-34
Removing the LNB/
Feed Tube Assembly
Motor Cable
#8-32 Screws
(x 4)
Skew Belt