Filter
Top Products
10. Position the baseplate assembly in place over the
mounting holes, with the baseplate’s connectors
(shown in Figure 2-6) facing the stern. Ensure that
all mounting holes line up and make any
necessary adjustments.
11. Connect the N-type connector end of the
data/power cable (from belowdecks) to the
baseplate, as shown in Figures 2-8 and 2-9.
54-0198
28
TracVision G8 Owner’s Manual - Guide to Technical Information
Figure 2-9
Connecting the Data/Power Cable
Figure 2-6
Location of Baseplate Connectors
Connectors
Figure 2-7
Baseplate Connectors
RF3
RF1
RF2
RF4
Data/Power
F-type Connector N-type Connector
To MCU To Antenna
Figure 2-8
Data/power Cable Connectors
Be sure to properly align the
data/power cable with the
baseplate connector before
tightening. Connecting the cable at
an angle may damage the cable’s
center tines.