Filter
Top Products
28 TV Channel Programming
Although the Recorder selects available TV channels during Initial Setup,
you may want to repeat the process later if more channels become
available in your area.This will erase and replace all previously stored
channels.To update the available channels, follow these steps.
● Make sure the Recorder is in DVD mode. Press DVD so the DVD light
appears on the front of the Recorder.
1
Press SYSTEM MENU. Press
ss
to select in the top left
corner of the menu bar at the top of the TV screen.
2
Press
LL
repeatedly to select at the bottom of the second
menu page, then press
BB
to enter the Installation menu.
3
Auto Ch. Programming will be selected. Press OK. “Searching for
TV channels” will appear, along with a progress scale.The number of
channels found will show on the screen as the searching progresses.
This will take a few minutes, depending on the number of channels
available.
4
When the channel search finishes,“Auto ch. search
complete” will appear, along with the total number of channels
found.
Press SYSTEM MENU. The Installation menu will reappear.
If you are satisfied with the channels found, press SYSTEM
MENU repeatedly to remove the menu.You are finished.
To add or delete additional channels, press
LL
to select
Add/Delete Channels, then go to step 5.
5
Press
BB
. A channel list will appear. Beside each channel number,
you will see “Delete” or “Add.”
6
Press
KK
or
LL
to select the channel you want to add or
delete, then press
ss
or B to choose Add or Delete for that
channel. Press OK to store your choice. “Stored” will appear
briefly in the lower left corner of the menu.
Repeat step 6 as often as necessary to add or delete all the channels
you want.
7
Press SYSTEM MENU repeatedly to remove all the menus
when you are finished.
Installation
K Auto Ch. Programming
u B Add/Delete Channels B
L
VCR Plus+ ch.
Time/Date
Cable/Antenna
To exit press
SYSTEM MENU
Installation
K
u B Auto Ch. Programming B
L
Add/Delete Channels
VCR Plus+ ch.
Time/Date
Cable/Antenna
To exit press
SYSTEM MENU
• Access added channels by
pressing CHANNEL +/-.
Deleted channels will be
skipped. Delete channels you
rarely watch.You still can select
deleted channels with the
Number buttons.
• If new channels become
available, or if you receive a
channel the Recorder did not
set, add the channel.
• The Recorder detects whether
you connected an Antenna or
Cable TV signal. If you are not
receiving the correct channels,
reset your channels. Follow
steps 1-2 above. Press
L
to
choose Cable/Antenna, then
press B. Press B or s to
choose Cable,Anten. (antenna),
or Auto (for the Recorder to
detect automatically). Press OK.
“Stored” will appear briefly in
the lower left corner of the
menu. Press SYSTEM MENU.
Press OK again to reset the
channels.When the search
ends, press SYSTEM MENU
repeatedly to clear the screen.
Helpful Hints
1,4,7
1-6
E9490UD_EN.qx3 04.9.21 10:54 AM Page 28