Filter
Top Products
User Guide
17
Customizing your RC5400
7 Switch back to DELETE mode and delete the device if it is not a
good match to your component. Repeat steps 4 through 7 until
all of your remote controls have matching devices.
8 Switch to LABEL mode to relabel each device
(see page 30-32).
9 Switch to MOVE mode to re-order your devices, so that your
Device Overview page is arranged the way you want (see page
39).
10 Switch to LABEL mode to relabel any buttons as needed to
match your existing remote controls. Check all of your devices.
12 Switch to LEARN mode and teach the RC5400 all of your non-
Marantz components’ RC Codes (see page 26-30).
13 Switching back and forth between USE and LEARN modes, test
all codes and reteach as necessary.
Note Be very careful to NEVER delete the jump tabs; they can only
be restored with a Editor software using PC. (see page 46-47).
14 Switch back to LEARN mode. Teach each Device the
appropriate Preamp/Receiver Input (source switching) IR
command (see page 28) as the Device Action.
Congratulations!
You have completed the first stage of customization. Take a well
deserved break.