Filter
Top Products
User Guide
44
Warning To use the Remote Control with Radio Frequency (RF) you need
an Marantz RX-77 RF Extender.
This is an optional accessory for the RC5400.
By default, the RC5400 uses
infrared (IR) signals to operate devices.
This means that you have to point the
RC5400 s IR sending eye towards
the devices you re operating. IR signals
have an operating distance of approximately
10 meters (33 feet).
You can choose to operate devices using Radio Frequency (RF)
signals instead of IR signals. RF signals can, unlike IR signals, go
through obstacles like furniture or walls.
The RF signals sent out by the
RC5400 are picked up by the RX-77
RF Extender. The RX-77 translates
the RF signals in IR signals and
sends the IR signals to the
appropriate devices. Therefore, the
RX-77 has to be placed near the
devices you re operating with the
RX-77 s sending eye pointed to the device.
Your devices will always receive IR signals either directly from the
RC5400 or from the RX-77.
Changing the IR / RF Settings
All devices are set up by default to work with IR signals. To be able
to operate one or more devices with RF signals, you have to
change the RC5400 s IR/RF settings for those devices.
1 Tap and hold the MODE icon in the LOWER TOOL BAR
more than 3 seconds. Mode Menu page will appear.
2 Tap the IR / RF button to switch to IR/RF Setting mode.
The RC5400 displays the device list box
.
Reference
7. Using the RC5400 with Radio Frequency
IR signal
IR signal
RF signal
RX-77