Filter
Top Products
User Guide
53
Frequently Asked Questions
How do I calibrate the Touch Screen?
The RC5400 is calibrated when it leaves the factory, so normally
you do not have to calibrate it yourself. It is possible that the
RC5400 displays a message to calibrate the Touch Screen. If this
message appears do the following.
1 Tap the INFO button in the Upper Tool Bar.
The information page will appear.
2 Tap the SETUP button in the Information page.
The first Setup page appears.
Navigate to third Setup page by using the Page + and Page -
buttons.
3 Tap the Calibration button.
4 Tap as close as possible the marker in the upper left corner
using a blunt tip of a pencil.
You will see the instruction “Touch TOP LEFT corner”.
5 Tap as close as possible the marker inthe upper left corner
using a blunt tip of a pencil.
You will see the instruction “Touch BOTTOM RIGHT corner”.
6 Tap as close as possible the bottom right corner using a blunt tip
of a pencil.
You will see the message Calibration succeeded .
7 Return to USE mode by tapping the INFO button again or
press the Left Function button labeled Exit .