Filter
Top Products
User Guide
52
Frequently Asked Questions
Can I program a device button to execute more than one
command?
Yes, you can. You can program a macro to the device button in the
MACRO mode. (see page 42).
How do I program source switching?
See “Programming The Device Buttons ...” on page 28.
How can I edit buttons which are programmed macro on
Device overview pages?
You can do this using Macro to device function via the MACRO
mode. (page 43).
How can I label buttons on Device overview pages?
You can do this using Label device function via the LABEL mode.
All changes you make to these items are automatically updated in
the Home page (page 32).
How can I delete buttons on Device overview pages?
You can do this using Delete device function via the DELETE
mode. All changes you make to these items are automatically
updated in the Home page (page 38).
How do I reset the RC5400?
Normally, you never have to reset the RC5400. However, if the
RC5400’s display freezes or if you notice unusual behavior, you
might need to reset the RC5400. You will not lose any saved
programmed commands or macros.
Carefully press the reset button near the battery connector inside
the battery compartment of the RC5400 with a paperclip or sharp
pencil. The RC5400 restarts and beeps to indicate it is ready for
use.
Can I revert to the original configuration?
Yes, by using the Revert function on the third Setup page or
Wizz.it with Windows PC. By using Wizz.it, once the program is
installed, open a configuration file named RC5400_default in
C/:Program Files/Wizzit/Samples. Downloading this configuration to
your RC5400 will restore your RC5400 to its factory state except
the setup items.