Filter
Top Products
41
5.3 CLOCK / TIMER / SEQ SETTING
The NVR-2028 provides a weekly table, consisting of two periods of time each day for scheduled
recording. This option allows you to set the time each day that the NVR will start and stop recording.
CLOCK SETTING:
This entry allows users to set the system time.
NOTE: Clock data is retained for about 3 months after the 15-hour power supply is used up
(Operate On mode).
TIMER:
This entry allows users to program the time each day that the NVR will start and stop recording.
There are two time periods each day available for scheduling. The time is displayed in a 24-hour
clock format. If there is a time overlapping showing between two continual time period settings, the
device will automatically combine the two time-period settings into one combined time-period
setting.
TIMER ENABLE: This option enables/disables the programmed scheduled recording.
ON: Enables the scheduled recording.
OFF: Disables the scheduled recording.
SEQUENCER:
To regulate dwell time of the sequencer, you can use the “
^” button and the “v” button to
select dwell time provided here, ranging from the "00" to the "30".you can set individual channels
in different dwell time. After set individual channels, quad and multi screen in different modes and
then push the Enter button
. At once the legends "OK" and "CANCEL" appear at the bottom
of the page. Now press the “<” button
and the “>” button to confirm either "OK" or
"CANCEL" respectively. Press "OK" to ratify your choice(s). If not, press "CANCEL".
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
GOTO CLOCK / TIMER / SEQ PAGE
CLOCK / TIMER / SEQ
CLOCK SETTING : SET
TIMER : SET
SEQUENCER : SET
MAIN PAGE
SET CURRENT CLOCK
REC SCHEDULE
TIMER ENABLE: ON
START END START END
S 06:00-16:00 12:00-18:00
●
●
●
●
REC SCHEDULE
TIMER ENABLE: ON
START END START END
S 06:00-18:00 00:00-00:00
●
●
●
●