Filter
Top Products
59
9. Wireless Network Configuration
9.1 Configure Your NVR-2028 Network Settings
Upon wireless network hardware connection, you need to activate the wireless network function
and configure the proper network settings of the NVR.
9.1.1 Enable DHCP Function
Use the “^” and “v” buttons , and , to highlight NET DHCP; select ON. Then press the
Enter button to proceed.
NOTE: This function can only work if the LAN which the unit is connected to has a
DHCP server. If the DHCP server is working, the NVR will obtain an IP address
automatically from the DHCP server. In that case please skip the section 9.1.2
(Set IP address) and follow section 9.3 (TCP/IP Communication Software).
9.1.2 Set IP Address
You don’t need to set a NET IP for the unit if the LAN which the unit is connected to has a
DHCP server. Otherwise, please follow the instructions given below:
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
WIIRELESS : SET
WAN SETTING : SET
NET IP : SET
NET DHCP : SERVER
LEASED IP TABLE : ENTER
COMM ID : 01
RS232 : ON
MAIN PAGE
SET ETHERNET DHCP
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
WIIRELESS : SET
NET IP : SET
NET DHCP : OFF
LEASED IP TABLE : ENTER
COMM ID : 01
RS232 : ON
MAIN PAGE
SET NETWORK