Filter
Top Products
Network Stand Alone DVR
Network Stand Alone DVRNetwork Stand Alone DVR
Network Stand Alone DVR
Network (JPEG2000+H.264)
Network (JPEG2000+H.264)Network (JPEG2000+H.264)
Network (JPEG2000+H.264)
27
(3) CAMERA ACTIVE SETUP : With direction button, move to option to be changed, and press [ENTER]
button to select [ON/OFF]. If it is set at LIVE [OFF] and REC [ON], DVR
system records, but does not show live image of set channel.
- STATUS : Shows if image from a specific channel is coming for live display and recording. In normal
camera condition, it is ACTIVE, but LOSS is displayed when the cable is disconnected or
camera is not working.
- LIVE : Decides whether to show LIVE screen image or not.
- REC : Decides whether to record relevant channel or not.
CAMERA ACTIVE SETUP
CH STATUS LIVE REC
---------------------------------------------------------------------------
01
02
03
04
05
06
07
08
ACTIVE
ACTIVE
LOSS
ACTIVE
ACTIVE
ACTIVE
LOSS
ACTIVE
ON
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
SELECT : ▲▼ ◀▶, & [ENTER]
(4) MOTION SETUP: You can set sensitive of motion detection in 4 steps, motion detection area and others
in relation to motion recording in this menu.
(4)-1. MOTION CONFIGURATION
- SENSITIVITY GRADE : Adjusts motion detection sensitivity. (LOW, MEDIUM, HIGH, VERY HIGH)
- MOTION DISPLAY TYPE : Showing cells with motion detected differently from cells with no motion .
- RECORD DURATION : Whenever motion is detected and it is set at Motion Recording mode, DVR
system records for RECORD DURATION from time motion is detected.
(1sec. ~ 99 sec.) (Default duration : 5 sec.)
(4)-2. MOTION MASK SETUP: Set motion detection area. Direction button is for moving and [ENTER]
button is for selection, and [MODE] button is for changing mode of MASK SETUP.
- CELL : Move to the location which you want to detect and then press the [ENTER] button.
Highlighted cell area means motion detection area.
- ALL ON : Set all cells as detection area. Use [ENTER] button to set.
- ALL OFF : Set all cells as no-detection area. Use [ENTER] button to set.
- BLOCK ON : Select detection area by block. Use [MODE] button and press [ENTER] button to set ON.
- BLOCK OFF : Select un-detection area by block. Use [MODE] button and press [ENTER] button to set ON.
Highlighted Area
(Motion Detection Area)
Non-highlighted Area
(No Motion Detection Area)
CHAP. 5 Set Up
MOTION CONFIGURATION
CHANNEL
SENSITIVITY GRADE
MOTION DISPLAY TYPE
RECORD DURATION
NUMBER OF CELL OT DETECT
01
01
OFF
05 SEC
02
SELECT ▲▼, CHANGE VALUE : + -