Filter
Top Products
Network Stand Alone DVR
Network Stand Alone DVRNetwork Stand Alone DVR
Network Stand Alone DVR
Network (JPEG2000+H.264)
Network (JPEG2000+H.264)Network (JPEG2000+H.264)
Network (JPEG2000+H.264)
33
CHAP. 5 Set Up
USB SETUP
HDD
START 2005/AUG/07 AM04:04:12
END 2005/AUG/08 PM08:12:23
USB MEDIA
START 2005/AUG/07 AM04:04:12
END 2005/AUG/08 PM08:12:23
SIZE 00000MB
BACKUP
USB STORAGE IS CHECKING
EXIT : [MENU]
5-6. EXTERNAL DEVICE
Set parameters of external devices connected to DVR, like Ethernet, PTZ camera, RS-232C, etc.
Use direction button to move to sub-menu and Press [ENTER] button to set.
System Status Messages
(1) If USB MEMORY STICK is not inserted :
- USB STORAGE IS CHECKING
- USB STORAGE IS NOT AVAILABLE
- RE-CONNECT THE USB STORAGE
- CONECT THE OTHER USB STORAGE
(2) When USB MEMORY STICK is recognized
- USB STORAGE IS CHECKING
- THERE IS A FREE SPACE ON STORAGE
- USB STORAGE IS AVAILABLE
(3) During Back-Up
- CHANGE WRITE PROTECT MODE (Only WRITE PROTECT is caught, it can be seen)
- START WRITING IN USB STORAGE
- FINISH WRITING IN USB STORAGE
(4) Error Message
- THERE IS A PROBLEM ON USB PORT (If USB PORT fails to work properly)
- USB STORAGE IS FULL (When USB is full)
- FILE SYSTEM IS NOT SUPPORTED (If File System is not supported)
- SIZE IS LARGER THAN FREE SIZE (If back-up size is larger than free space)
USB SETUP
HDD
START 2005/AUG/07 AM04:04:12
END 2005/AUG/08 PM08:12:23
USB MEDIA
START 2005/AUG/07 AM04:04:12
END 2005/AUG/08 PM08:12:23
SIZE 28 MB - > 28MB
BACKUP
START WRITING IN USB STORAGE
EXIT : [MENU]
IP CONFIG SETUP
MAC ADDRESS
IP ADDRESS
IP PORT
GATEWAY
SUBNET MASK
DHCP SETUP
_ _ _ _ _ _ _ _ _ _ _
00-0A-A2-00-00-00
_ _ _ _ _ _ _ _ _ _ _
192.168.001.160
_ _ _ _ _ _ _ _ _ _ _
50000
_ _ _ _ _ _ _ _ _ _ _
192.168.001.001
_ _ _ _ _ _ _ _ _ _ _
255.255.255.000
AUTOMATIC
SELECT MENU : ▲▼, & [ENTER]
1) TCP/IP SETUP
TCP/IP function enables user to see live pictures and
recorded pictures via the internet.
(1) IP CONFIG SETUP :
Show the network information assigned to the DVR
unit. If the DHCP setup status is AUTOMATIC, user
can set the IP port only and if the DHCP setup status
is MANUAL, user must set all parameters.
For detail procedure of Remote viewer program
installation, refer to CHAP. 6 Software program.
(Remote viewer software).
※ Back-Up procedure is the same as CDR Back-Up.
※ If Back-Up size is larger than 2GB, it creates several files. (It saves by 2GB).
Status message