Filter
Top Products
Microboards Technology, LLC
28
Error
Code
Error Message Description and Recommended Solutions
232 Format Failed!
The hard drive was not able to be formatted. An
additional error code will be displayed as XX-YY, with XX
being the index of the drive with the error and YY being
the error code.
Possible hard drive failure; contact Technical
Support.
233 Hard Drive Corrupted
The hard drive is corrupted and the information on the
drive cannot be accessed.
Reformat the hard drive.
235
Hard Drive Access
Error
The duplicator encountered an error when attempting to
access the hard drive.
Possible hard drive failure; contact Technical
Support.
240 Wrong Password
The password that was entered is not correct.
Confirm the correct password is being used or use a
different password.
241 Login Failed
An incorrect password was entered 3 times
consecutively.
Wait 5 minutes, then re-
enter the correct password.
Contact Technical Support if the problem persists.
251 Copy Audio Error
Applies to Mix Audio Tracks. An error occurred during
the Mix Audio process. Could be caused by either a
master error or a recording error.
Try a different master or blank disc.
252 Not Audio CD
Applies to Mix Audio Tracks. The master disc is not an
Audio CD.
Verify the master disc is an Audio CD.
253
Over Blank Disc
Capacity
Applies to Mix Audio Tracks. The total size of the
selected tracks is larger than the remaining capacity of
the target discs.
Select alternate track of smaller size, or remove
selected track.
260 No Update File
A valid firmware file was not detected on the disc during a
Firmware Update attempt.
1. Confirm the file on the disc is not a “zip” file. If
so, extract the file and burn to another disc.
2. Confirm that the update disc was burned as a
“Mode 1” Data CD. Drag-and-drop burn methods
such as the Windows XP burn utility generally do
not use this format and will not be recognized.
3. Verify that there are no other discs loaded in the
duplicator. Insert the update disc in another
drive tray and repeat.
261 Wrong Update File
The Firmware Update File is either not compatible with
your duplicator or is corrupted.
Download and burn Update File again. Contact Tech
Support if this error persists.
262 Unknown Flash Model
The Firmware Update File is not for your duplicator.
Contact Tech Support for the correct file. Have
Duplicator Model and Serial Number available.
263 User Abort
A duplication job has been deliberately cancelled by the
user by pressing the ESC button for more than 5 seconds
during a duplication attempt.
Once the reason for cancellation has been corrected,
restart the job after replacing any partially burned
media.