Mitsubishi Electronics HS-S8300E(BRS) VCR User Manual


 
15
ENTER
FF
CLEAR
REW
JOG/ADJUST
SHUTTLE/ENTER
REC
STOP
PLAY
POWER
EJECT
PICTURE
TRACKING
POSITION/
VERTICAL
ADJUST
REC/PLAY
MODE
COUNTER
RESET
COUNTER MEMORY
SKIP/INDEX
PAUSE/
SHUTTLE HOLD
DISPLAY
TIMER REC
VIDEO
SOFT
SHARP
COLOR
B/W
Video cassette tapes can be loaded into your new VCR as long as the VCR is plugged into a power source. Even if the VCR power
switch is turned off, loading a cassette will automatically cause it to turn on. Use only video cassette tapes marked
V V
V V
V or
SS
SS
S.
Do not use a E-240 or SE-240 cassette tape when recording in 48H - 960H or 0H mode.
LOADING
1 To position the cassette properly before inserting it in the cassette slot, hold
the cassette so that the long narrow edge with the contents label faces towards
you. The other long narrow edge is hinged and should face towards the VCR.
The clear plastic window that shows the video tape should face upward.
2 Gently insert the videotape into the cassette slot to a point where the VCR
automatically retracts the cassette.
When you insert the videotape, be sure to align it squarely to the slot.
NN
NN
N
Your new VCR has a protection circuit which will eject the tape if it is loaded
improperly. If the VCR ejects the tape you are trying to load, remove it
completely and check that the long narrow edge with the contents label is
facing towards you and that the clear plastic window that shows the video
tape is facing upwards. Then try again.
UNLOADING
11
11
1 Press the EJECT button on the front of the VCR.
22
22
2 Remove the cassette.
NN
NN
N
Your VCR will eject a video cassette even if it is in STANDBY mode. When
the EJECT button is pressed, the VCR will automatically turn on, eject the
tape and turn off. It is not possible to eject a tape whilst recording without first
pressing the STOP button. A tape cannot be ejected when the VCR is locked.
PREVENTING ACCIDENTAL ERASURE
Video cassettes come with an erasure prevention tab which, when removed,
prevents the tapes contents from being erased or recorded over. A cassette
without the erasure prevention tab will automatically be ejected from your VCR if
you attempt to record on it.
N
We recommend that any torn or broken cassette tape requiring repair should
only be taken to professionals who specialise in such procedures. The
adhesives on many common types of tape could damage the head of your
VCR.
LOADING AND UNLOADING THE CASSETTE TAPE
CORRECT
INCORRECT