Filter
Top Products
7
CONNECTING WITH OTHER EQUIPMENT
AUDIO
OUT
MIC IN
VIDEO
OUT
VIDEO IN
AUDIO IN
MONITOR
SET IN
SENSOR
VIDEO
OUT
CCTV
CAMERA
VIDEO
IN
MIC
VIDEO
OUTIN
IN
OUTMIC
AUDIO
RESET
REMOTE
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
IN OUT
S-VIDEO
OUT
IN
RS-232C
VERTICAL ADJUSTMENT (Correcting picture vibration at the top and bottom)
The picture vibration can be reduced or eliminated by the following steps.
1 If the vibration occurs in still, slow motion, fast playback (x2) or normal playback in 12H - 960H or 0H mode,
playback a tape which is recorded in 3H mode with this VCR and press the PAUSE button.
If the vibration occurs during normal playback in L12H or L24H mode, playback a tape in each playback mode.
2 Press the VERTICAL ADJUST (+) or (-) button to reduce or eliminate the picture vibration.
N
• When QUASI V-SYNC is set to “OFF”, the picture vibration is not adjustable with the VERTICAL ADJUST buttons.
MONITOR TO BE CONNECTED
• Connection with a CCTV monitor (for surveillance) is recommended.
• Connecting with some monitors may cause picture vibration and/or picture distortion at the top or bottom of the image
during still or normal playback.
A domestic Television used as a Monitor may be unable to provide a stable picture without vibration and distortion.