Stand Removal Instructions
Before attaching the wall mount kit to the TV, b
e sure
to
connect all necessary cables to jacks on the
back of the TV. After wall-mounting, these jacks
will not be accessible.
If you plan to connect a PC to the TV, before wall-
mounting be sure to connect a DVI cable (or a
DVI/VGA
adapter
cable
) to the PC-DVI video input
on the back of the
TV
. For PC audio, connect an
RCA cable to the PC-DVI right/left audio inputs.
IMPORTANT
CAUTION
• A minimum of TWO PEOPLE are needed to safely remove the stand.
• One person needs to hold the TV, while the other person removes the stand.
• Failure to follow these recommendations may result in personal injury as well as damage to the product.
1. Before starting to remove the stand, make
sure to disconnect the AC power cord from
the AC power outlet.
2.
Spread the protective sheet that was wrapped
around the TV on a flat, even surface (such
as a sturdy table). The protective sheet will
help prevent the display from being damaged.
IMPORTANT: To avoid damaging the screen,
make sure there are no foreign objects
under or on top of the protective sheet.
3. With two people firmly grasping the left and
right sides of the
TV
, gently place the
TV
face
down on the protective sheet with the display
stand hanging over the edge of the table.
See the illustration to the right.
4. LT-37132 model: Disconnect the Power
Swivel Cable from the
TV
only.
LT-46231 model: Skip Step 4. This model
does not include the Power Swivel feature.
Both TV models can be swiveled manually 30
degrees left and right.
5. Use a Philips screwdriver to remove the four
(4) stand screws. See the illustration to the
right.
6. While one person holds on to the TV with
both hands, the other person grasps the
plastic portion of the stand (see illustration
to the right) and removes the stand by pulling
it away from the TV in the direction of the
large arrow shown in both illustrations.
Place the stand and screws in a safe place
for future use.
7. The
TV
is now ready for mounting. Refer to
the instructions provided with the Wall Mount
Kit (purchased separately).
Wall Mount Kit
To order a Wall Mount Kit (Part #
PSM-2031)
:
Please call the
Mitsubishi
Parts Department at
(800) 553-7278, or call Chief Manufacturing,
Inc.
at (800) 582-6480.
Note: Complete wall-mounting instructions
are included with the wall mount
kit.