Filter
Top Products
62 Chapter 5. TV Menu Settings
Setup Menu
See chapter 3, “TV Setup,” for use of the Setup menu.
NetCommand Menu
The features described in this section are available even if
you have not performed NetCommand setup. See chapter
3, “TV Setup,” for options available for NetCommand-con-
trolled devices.
Review TV Connections
(no NetCommand setup required)
Press to highlight Review and press
ENTER
to
display the Review screen (see figure 2).
To turn a connected input On or Off, highlight the check
box for the input and press
ENTER
. This either adds or
removes a check mark. A check mark adds/removes an
icon from the Input Selection menu. Inputs shown in gray
indicate that these inputs do not have a device connected,
and can not be turned On or Off.
Figure 2. The Review screen lists all TV connections.
IEEE 1394 inputs are listed separately on the right.
Input Name Menu
(no NetCommand setup required)
Use the Input Name menu to assign useful labels to the
TV inputs that appear in the Input Selection menu. See
figures 3 and 4. The current viewing device and any
unused inputs appear grayed out and unselectable in the
Input Name menu.
Icon for the Input Name menu
Icon for the Icon Order menu
Figure 3. The Input Name menu and Icon Order menu are
accessible through the NetCommand menu.
Figure 4. Input Name menu
To rename an input
1. If you are currently watching the input you wish to
rename, first change to another input. To do so, press
INPUT
to open the Input Selection menu, highlight a dif-
ferent input, and press
ENTER
.
2. With the Input Name menu displayed, press
to
move the highlight to the box for the input you wish to
rename.
3. Press
to select from the following list.
Cable Box Game
Camcorder HD Disc
DVD Satellite
DVD2 VCR
DVR
(digital video
recorder, recordable DVD)
Only one VCR label is available, so If you have a
second VCR connected, leave the name as the default
name.
To Replace One Device with Another on an Input Jack
1. Disconnect the device you wish to remove from the
TV.
2. Connect the new device to the vacated jack.
3. Open the Input Name menu from the NetCommand
menu.