Filter
Top Products
38 Chapter 3. TV Setup
When You First Power On the TV
Choosing a Language for Menus
When you power on the TV for the first time, you can
select either English or Spanish for all menus. You can
later change the language through the Setup menu.
Figure 1. The Welcome screen lets you change the menu
language when you first power on the TV.
TV Guide On Screen Setup Reminder
If you do not set up the TV Guide On Screen system when
you first turn on the TV, a reminder screen will appear the
next six times you turn on the TV (see figure 2). To set up
the TV Guide On Screen system, see “Additional Setup
with the NetCommand Menu” later in this chapter.
Figure 2. TV Guide On Screen setup reminder
Using the TV’s Setup Menu
Use the Setup menu for basic TV setup options. To
display the Setup menu, press
MENU
to open the Main
menu. With the Setup icon highlighted, press
ENTER
.
The Main menu
appears when
you press
MENU
.
Figure 3. Open the Setup menu from the Main menu.
Language (Setup Menu)
Choose to display on-screen menus in either English or
Spanish (Español).
To listen to audio in other languages (when available), see
chapter 5, “TV Menu Settings, and the “Audio Settings”
section. Then refer to either “SAP” (analog signal) or
“Language” (digital signal).
Memorize Channels (Setup Menu)
For ANT 1/MAIN and ANT 2/AUX
The memorization process performs two scans of all pos-
sible channels on the selected
ANT
input. Analog chan-
nels are scanned first, then the process is repeated for
digital channels. Channel memorization may take up to 15
minutes to complete.
To start channel memorization
1. Highlight an antenna input based on your connections:
Input Condition
Ant 1 Air,
Ant 2 Air
When connected to an indoor/outdoor
antenna
Ant 1 Cable,
Ant 2 Cable
When connected to direct cable (no cable
box)
2. Press
ENTER
to start automatic channel memorization.
To stop channel memorization before completion
Press
CANCEL
.
Channels memorized before you pressed
CANCEL
are
retained in memory. If you restart memorization, all previ-
ously memorized channels for the selected antenna input
are erased and the process restarts.
After channel memorization, press
CH
/ to tune to
memorized channels. Select the Channel menu for further
channel editing, such as adding and deleting channels
from memory, naming channels, and saving favorite chan-
nels in custom memory banks.
Note:
• If using a CableCARD™, the complete list of avail-
able channels is provided through the CableCARD
and the ANT 1 option is grayed out.