Filter
Top Products
12
Part II : Installation
Front Control Panel
Many remote control buttons are duplicated on the front control panel. These buttons are shaded in figure 1.
Please see Remote Control Functions, pages 48 - 55, for an explanation of their usage.
Figure 1. Front Control Panel Figure 2. Located under Control Panel Overhang
1
Status indicator
This indicator informs of the status of the projection TV. See below.
2
Power indicator
This indicator informs of the power condition of the projection TV. See below.
3
A/V Reset
Press this button to reset the A/V memory on all inputs to the factory default settings. Please
see
A/V Memory Reset
, page 41, for instructions.
4
PC-2
This input can be used for the convenient connection of a compatible computer. Please see
Appendix B
, page 59, for signal compatibility.
5
Input 5 (S-VIDEO / VIDEO)
This input can be used for convenient connection of a camcorder or other video device. Please
note that if you connect to the S-VIDEO terminal, the VIDEO terminal is deactivated.
6
L - AUDIO - R
Audio input to the AUDIO IN terminal on the front panel is possible for a component connected
to either PC-2 or Input 5.
Front control Panel Functions
STATUS POWER
POWER
VOLUME
ADJUST
CHANNEL ENTER
ENTER
ADJUST
MENU
MENU
A/V RESET
CANCEL
INPUT
1 2
3
S-VIDEO VIDEO
PC-2
INPUT - 5
L–AUDIO–R
4 5
6
Steady
green
STATUS POWER
CONDITION NOTES
Under normal operation
Abnormal operation notice
The POWER is ON
Lamp start-up (for 30 seconds)
Off
OffOff
Steady
yellow
Steady
yellow
Off
Off
Initialization when first plugging inyour TV, or lamp cooling
(10 - 45 seconds)
Stand-by (When the TV is set to turn on at a specific time.)
TV will turn on in 10 - 30seconds.
• Close the cover correctly.
Off
Off
Off
Off
Off
Blinking
green
Any state
Blinking
yellow/red
STATUS POWER
CONDITION POSSIBLE SOLUTIONS
Lamp usage warning. (Usage total about 4, 000 hours.)
Lamp failure
Lamp cover or filter cover is open.
Service required. • Contact your dealer.
Unusual temperature
• The air-filter is dirty.
• The room temperature is too high.
• Clean the filter. (See page 64).
• Relocate the projector to a cooler place.
• Replace the lamp. (See page 61.)
• Wait 1 minute, then press the POWER button.
• If the above operation is not effective, replace
the lamp.
Blinking
red
Blinking
yellow/green
Blinking
red/green
Off
Steady
red