Filter
Top Products
Chapter 2. Connecting 25
Antennas with Separate UHF and VHF
Leads
Figure 4
A UHF/VHF combiner is required. This is not included with the
TV, but is available at most electronics stores.
1. Connect the UHF and VHF antenna leads to the UHF/
VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV back
panel.
COMPONENT
YPbPr (480i/480p/720p
INPUT
1
2
S-VIDEO
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
DTV/CABLE/
VHF/UHF
ANT 1 / MAIN
ANT 2 / AUX
DIGITAL
AUDIO
OUTPUT
1
2
Net Command
IR EMITTER
¸
',INK
¸
COMPONENT
YPbPr
(480i/480p/720p
INPUT
1
2
S-VIDEO
S-VIDEO
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
ANT 2 / AUX
1
2
Net Command
IR EMITTER
¸
',INK
¸
&YUFSOBM
"OUFOOB
PS$BCMF
#BDL
7JFX
4JEF
7JFX
'MBU5XJO-FBE
6)'"OUFOOB
$IBOOFMT
7)'"OUFOOB
$IBOOFMT
0INUP
0IN
$PNCJOFS
'MBU5XJO-FBE
6)'
7)'
57CBDLQBOFMTFDUJPO
4O!.4-!).
Figure 4. Connecting separate UHF and VHF Antennas
Connecting an Antenna with a Single Lead or Antennas with
Separate UHF and VHF Leads
Antenna with a Single Lead
(not for use with CableCARD™)
Figure 3
For antennas with flat twin leads
A 300-ohm-to-75-ohm transformer is required. This is not
included with the TV, but is available at most electronics stores.
1. For an antenna with flat twin leads, connect the
300-ohm twin leads to the 300-ohm-to-75-ohm
transformer.
2. Push the 75-ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For cable or antenna with coaxial lead
Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
DTV/CABLE/
VHF/UHF
ANT 1 / MAIN
ANT 2 / AUX
DIGITAL
AUDIO
OUTPUT
Net Command
IR EMITTER
¸
¸
ANT 2 / AUX
OUTPUT
Net Command
IR EMITTER
¸
¸
0IN
'MBU5XJO
-FBE
0IN
$PBYJBM
$BCMF
0QUJPOBM0INUP0IN
.BUDIJOH5SBOTGPSNFS
57CBDLQBOFMTFDUJPO
Figure 3. Connecting a Single Antenna
Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.