Filter
Top Products
47
6
NetCommand
About NetCommand
• NetCommand home-theater control is available on
the following models:
Y series WD-Y577, WD-Y657
734 series WD-57734, WD-65734, WD-73734.
This chapter applies only to these models.
• NetCommand setup is optional.
• You can perform NetCommand setup when the TV
first recognizes a device during Auto Input Sensing
or at any convenient time afterward.
• NetCommand operates by sending remote control
signals from the TV to your other devices via the IR
emitters, telling the devices to play, record, change
inputs, adjust volume, change channels and many
more functions. All this is accomplished with the
TV’s remote control and the slide switch left in the
TV
position.
• The IR “Learning” feature of NetCommand allows
the TV to learn the remote control signals for your
A/V devices.
• You can choose the level of NetCommand control
for your home theater.
Standard Setup. Perform a standard setup if
you want NetCommand to control only a few
devices, such as the TV, a playback device (like
a DVD player), and a cable box. With this setup,
you can use the TV’s remote control to operate
these devices.
A/V Receiver Setup. Perform A/V receiver
setup if you want NetCommand to:
Control a surround sound A/V receiver.
Automatically change audio input selections
on an A/V receiver when you change inputs
on the TV.
Important Note on NetCommand
Be sure to connect the IR emitter cable to the
TV and properly place the emitters so that
Netcommand can control your devices. See the
explanation on the following page.