Mitsubishi Electronics WD-57833 Projection Television User Manual


  Open as PDF
of 96
 
88 Appendices
IEEE 1394 Devices
Symptom Remarks
5. ThereisnoaudioandvideofromtheIEEE
1394device.
• Thedeviceisnotturnedon.Turnthedevicepoweron.
• NotapeisinsertedintheDVCR.
• Themediaisblank(hasnorecording).
• Theplaycommandfailed.TrypressingPLAYagainonthe
device’sremotecontrolorfrontpanel.
• Thedeviceisalreadyinuse(forexample,thedeviceiscur-
rentlyrecording).
• Thesourceiscopy-protectedorviolatescopyprotection.
• Thedevice’sdigitalvideosignalisnotsupportedbytheTV,
asmaybethecasewithanIEEE1394signalfromacom-
puter.Useanalogconnectionsinstead,ifavailable.
• Thedeviceisnotanaudio/videodevice.
• ToomanyotherdevicesarealreadycommunicatingoverIEEE
1394.Removeorstopsomedevicesandtryagain.
6. TheIEEE1394devicecannotbeselected(is
grayedout).
•
Thedevicemaybebusywitharecording.Canceltherecording.
• YouhaveconnectedmorethansevenIEEE1394devices.
Unplugtheeighthdeviceandoneotherdevice.Plugthenew
devicebackin.
7. AllIEEE1394devicesdisappear. • Theconnecteddevicesmustnotbeinaloopthatreturnsto
theTV.Makesureadeviceisconnectedattheend.
• DisconnectallthecablesanddevicesfromtheTV.Replace
themonebyonetolocatetheproblemdeviceorcable.
• UseSystemReset(frontcontrolpanel).
8. AnIEEE1394devicehasbeenpluggedin
butdoesnotappearintheInputSelection
menu(notdiscovered).
• TheIEEE1394connectiontotheTVoranotherdeviceisnot
secureorisloose.
• TheIEEE1394deviceisnotpoweredon.
• AdeviceintheIEEE1394chainisnotpoweredon.Turnon
allthedevices.
• Thedevicediscoverycantakeaslongasaminutetoinitiate.
• IEEE1394cableistoolong(maximumof15feetbetween
devices).
• TheIEEE1394deviceusesanincompatibleprotocolandwill
notbediscovered
9. AnIEEE1394deviceisnotresponding
properly.
• Unplugthedevice’spowercord.Waitatleasttenseconds
andplugitinagain.
• SomeIEEE1394devicesarenotsupportedbytheTV
becauseofincompatiblestandards.
 previous next