Filter
Top Products
GB 14
First time installation
Language
• Select the desired menu language using the cursor up/cursor down button.
This will also become the main language for audio and subtitling.
•Press select to continue.
General information
Once you have correctly connected the Mediamaster, you will also have to perform
a “First-time installation.” During this procedure, helpful information is displayed
at the bottom of the menus.
Please note!
The select button always confirms a selection within these menus, and pressing
it will take you to the next step in the installation process. However, and this is im-
portant, more than one value often has to be entered in a menu. Firstly, make all
necessary setting changes. Then, confirm them all simultaneously by pressing
select.
You can always return to the previous menu by pressing back.
Use the cursor up/cursor down button to move upwards and downwards from
one line to another.
Use the cursor left/cursor right button to change settings.
You can also use the numeric buttons on the remote control to enter numeric val-
ues.
The “First-time installation” menu
This picture indicates that you have started the installation procedure.
•Plug in your Mediamaster.
• The “First-time installation” menu is shown.
•Press select to continue.
Antenna/satellite selection
• Select the “One antenna/one LNB configuration” alternative if you have a sin-
gle antenna equipped with one LNB for receiving signals.
• Select the alternative “Multisatellite/DiSEqC switch configuration” alternative
if you have one antenna with two or four LNBs or two antennas with one or two
LNBs each for receiving signals from a combination of satellites. In this cases
you will need a 2-way or a 4-way DiSEqC switch.
•Select the “Motor antenna configuration” alternative if you have an antenna mo-
tor to control your satellite antenna.