Filter
Top Products
GB 4
Time adjustment
The time is adjusted using the cursor up/cursor down buttons,
±half an hour at a time. You can also change the minutes using the cursor left/
cursor right buttons.
•Press select to finish the first-time installation and to open the Navi Bars.
Channel search in progress
This menu will be shown while the Mediamaster is searching for TV and radio
channels.
All channels that are found will be listed on the screen.
Please note that the search procedure may take a few minutes. You can cancell
the search at any time by pressing select.
When the search procedure has ended, a message will tell you how many TV and
radio channels have been found.
•Press select to continue.
Channel search
• Select the “Automatic search” alternative. Note that you can also choose to
search only for free channels by selecting the “Automatic search for free chan-
nels” alternative.
• Press select to start the channel search. Note that you can choose to skip the
channel search and select “Predefined channels”. This alternative allows you
to use only a few predefined channels that have been stored in the
Mediamaster at the factory.
One antenna/one LNB configuration
Select this alternative if you have one (1) LNB mounted on the antenna.
•Press opt to view the predefined channel.
LNB type
Select the correct LNB type for your configuration. The most common values,
including Universal LNB, can be selected using the
cursor left/cursor right button
.
LNB offset voltage
If the cable from the antenna is very long, the voltage at the LNB could be too
low to change the polarisation. You can increase the voltage to the LNB by 0.5
V.
Satellite
Select one of the pre-programmed satellites.
Predefined channel
Select one of the predefined channels and adjust the antenna until a TV picture
from the predefined channel is visible in the background.
• Press select to confirm all settings and then carry out the channel search pro-
cedure.
Quick guide