Filter
Top Products
GB 28
Navi Bars
Settings folder ☛ Time
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
The time is adjusted using the cursor up/cursor down button, half an hour at a
time. You can also adjust the minutes using the cursor left/cursor right button.
Settings folder ☛ Access
To open this menu you will be asked to enter your access code.
The access code is set to 1234 at the factory.
The following settings can be altered from this menu.
Access Control
Select “Yes” or “No” to turn the access control for all menus on or off. Note: Even
when “No” has been selected, the access code must still be entered before you
can watch locked channels.
Receiver lock
If you select “Yes” you will have to enter the access code every time you activate
the Mediamaster from standby mode.
Age rating control
If you want everybody to have access to all available types of programmes, select
“No”
If you select “Yes”, you may block programmes that are unsuitable for children.
Age Limit
Select an age limit between 3 and 18 years on the line that appears.
However, you should be aware that not all Service Providers have implemented
the necessary codes for these functions in their transmissions.
Change access code
You can change the access code from the standard factory setting of 1234.
DO NOT FORGET YOUR ACCESS CODE! Without it, you will not have access
to any of the functions that require the code!
‘letterbox’‘fullscreen’
Picture format
If you have a TV set with a 4:3 picture format and the transmission is 16:9,
you can select “Fullscreen” or “Letterbox”.
Fullscreen will fill the screen but some information on the left and right sides
will be cut off.
Letterbox will give a complete picture, but black areas will be visible at the
top and bottom of the screen.