Filter
Top Products
Chapter 2 • Initial Configuration
Initial Configuration
To operate MGW 2400 for the first time, you use
HyperTerminal to log on to MGW 2400's Configuration Utility.
To log on to MGW 2400's Configuration Utility you use the
user name Administrator. The default password for this user is
Administrator.
Configuring HyperTerminal
HyperTerminal is pre-installed on PCs that run on Windows
NT, 2000 or XP. For further information on HyperTerminal,
refer to the Microsoft Windows documentation.
Optibase has provided you with pre-configured HyperTerminal
settings, which are available on MGW 2400's CD. To apply
these settings, do the following:
1. Use a serial cable to connect MGW 2400’s RS-232 port to
the Configuration PC's serial COM1 port.
2. Switch MGW 2400 on and wait until it finishes booting,
which is the case once the Power LED turns green. You
cannot apply the HyperTerminal settings before.
3. On MGW 2400's CD, go to HyperTerminal Settings and
copy MGW2400.ht to your Communication PC.
4. Right-click MGW2400.ht, choose Properties and clear
Read-Only.
5. Double-click MGW2400.ht; HyperTerminal appears and
you can log on to MGW 2400's Configuration Utility.
If you do not have the CD available, you have to manually
configure HyperTerminal for first use.
20