RF
VIDEO1
VIDEO2
VIDEO3
YCbCr
HDTV-XGA
YPbPr
4. Switching on/off
Press the main POWER SWITCH (1) the
red power indicator lights up, the set is in
standby mode.
Press the POWER button (2) on the remote
controller to turn on the set, and the power
indicator turns to yellow. Or you can directly
press CH+ / CH- button on the set to turn
on the set.
To turn off the set completely, press the
main POWER SWITCH (1).
To turn off the set temporarily, press the
POWER button (2) the set is in standby
mode, the indicator turns to red.
When the remote operation is received by the set, the TIMER indicator (green) on the
set's front will glitter to inform the user.
The buttons in this manual refer to the ones on the remote controller if without special
indication.
5. Signal source selection
Press the AV/TV button (1) to display
signal source selection menu.
Press the CH or CH button (2) to
select one of RF / VIDEO1 VIDEO2/
VIDEO3 / YCbCr / HDTV-XGA / YPbPr.
Press VOL or VOL button (3) to
confirm your choice.
1)
2)
3)
(2)
(3)
(1)
(2)
!
1)
2)
3)
4)
5)
(2)
(1)