Panasonic AJ-D850A VCR User Manual


 
Controls and their functions
– 18 –
<Connector area>
!5 ANALOG COMPONENT VIDEO OUT connector
The analog component video signal is output from this connector.
!6 ANALOG COMPOSITE VIDEO OUT connectors
The analog composite video signals are output from these connectors.
The video signal with signals superimposed on it can be output from the VIDEO OUT3
connector.
The superimpose function can be set ON or OFF on the setup menu No. 006 (SUPER).
!7 DIGITAL AUDIO IN/OUT connector
This I/O connector is for digital audio signals which comply with the AES/EBU standard.
!8 SERIAL DIGITAL COMPONENT AUDIO/VIDEO IN/OUT connector
(optional AJ-YA750P interface board required)
This I/O connector is for digital component audio and video signals which comply with the
EBU Tech. 3267-E standard.
The connectors are known by different names when the AJ-YAC850P SDTI/SDI board
(option) is used. For further details, refer to the operating instructions of the AJ-YAC850P
board.
!9 Remote control connectors
The unit can be controlled from an external source by connecting the unit with another unit
or an external controller.
There are two remote control connectors, one for IN/OUT uses and the other for OUT
uses.
IN/OUT: For connection with an external controller.
For connection with deck-to-deck operation.
OUT: For connection with parallel running operations.
@0 ENCODER REMOTE connector
The external encoder/controller is hooked up to this connector when the video output
signal and other settings are to be adjusted from an external source.
@1 RS-232C connector
@2 PARALLEL REMOTE connector
This is used when operating the unit from an external source.