Filter
Top Products
– 45 –
MIC
AMP
ANALOGUE
AUDIO IN*
VIDEO
OUT
RECORDER
AJ-D850A
AG-A850
REMOTE
IN/OUT
CONTROLLER
Ref.
Microphone
TV monitor
* Connect to the channel (CH1 or CH2)
on which the sound is to be recorded.
1
Select INT_VO as the setup menu No. 322 (AUD MEM MODE) setting.
2
Select the same setting for the channel (CH1 or CH2) on which the sound is to be
recorded and for the setup menu No. 323 (AUD MEM CH) channel.
3
Insert the cassette tape for which the voice-over editing is to be performed into the
VTR.
4
Set the CONTROL switch on the VTR to the REMOTE position.
5
Set the controller’s SOURCE selector to AUX1.
6
Press the insert button for the channel (CH1 or CH2) on which the sound is to be
recorded.
7
Enter the IN and OUT points of the positions where voice-over editing is to be
performed.
8
Press the PREVIEW button.
9
While watching the TV monitor, input the audio signals to be recorded between the IN
point and OUT point into the channel that was selected in step 6. The audio signals to
be recorded are stored in memory.
10
Press the AUTO EDIT button to proceed with editing. The audio signals stored in the
memory are recorded from the memory onto the cassette tape.
<Note>
For further details on the AG-A850, refer to the operating instructions of the AG-A850.
For operation with an editing controller (AG-A850)