Filter
Top Products
21
SYSTEM menu
<SYSTEM> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
18 CHROMA 0000 –127
..
..
LEVEL
..
0127 0
..
..
..
0255 128
21 SYS H 0000 –3
OFFSET 0001 –2
0002 –1
0003 0
0004 4
0005 5
0006 6
22 SYS SC/H 0000 REMOTE
0001 LOCAL
30 MENU 0000 OFF
LOCK 0001 ON
The underline on the setting item denotes the initial setting.
Video output signal adjustments
The SYSTEM menu item No. 03 (ENCODER SEL) and No. 22 (SYS SC/H) settings are used to make the video
output signal adjustments. The table below shows the control matrix for these adjustments.
Setting Adjustment item
VIDEO LEVEL
SYSTEM menu item SYSTEM menu item
SYSTEM menu item
CHROMA LEVEL
03: ENCODER SEL 22: SYS SC/H
00: SYS SC COAR.
SET UP
01: SYS SC FINE
HUE
OFF
LOCAL
Unit Unit (SYSTEM menu)
REMOTE
ON
LOCAL Unit
External encoder remote
REMOTE External encoder remote
For setting the chroma level.
The maximum amount by which the level can be varied is from
–3 to +3 dB.
For adjusting the system phase offset: 4.48 µs steps
0: –13.4 µs
1: –8.96 µs
2: –4.48 µs
3: 0
4: +4.48 µs
5: +8.96 µs
6: +13.4 µs
<Notes>
• The setting remains unchanged even when the factory
setting operation is performed.
• When this menu item is used together with SYSTEM menu
item No. 02 (SYS H) setting, the adjustment is limited to a
range from –15 to +15 µs.
For setting whether the system phase is to be adjusted by the
unit or from the external encoder remote connector.
0: The system phase is adjusted from the external encoder
remote connector.
1: The system phase is adjusted by the unit.
<Notes>
• This setting remains unaffected when OFF is selected as the
SYSTEM menu item No. 3 (ENCODER SEL) setting.
• The range for the system phase adjustment using the
encoder remote connector is –3 to +3 µs. When this menu
item is used together with SYSTEM menu item No. 021
(SYS H OFFSET) setting, adjustment can be made from –15
to +15 µs.
This selects whether the system file lock mode is to be
engaged or released.
0: The lock is released (file data can be changed).
1: The lock is engaged (file data cannot be changed).