Filter
Top Products
31
USER menu
<TIME CODE>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
500 VITC 0000 10L
..
..
POS-1
..
0006 16L
..
..
..
0010 20L
501 VITC 0000 10L
..
..
POS-2
..
0008 18L
..
..
..
0010 20L
502 VITC 0000 BLANK
BLANK
0001 THRU
503 TCG 0000 TC&UB
REGEN 0001 TC
0002 UB
504 REGEN 0000 OFF
MODE 0001 ON
505 EXT TC 0000 LTC
SEL 0001 VITC
506 BINARY 0000 000
GP 0001 001
0002 010
0003 011
0004 100
0005 101
0006 110
0007 111
507 PHASE 0000 OFF
CORR 0001 ON
508 TCG CF 0000 OFF
FLAG 0001 ON
The underline on the setting item denotes the initial setting.
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-2 in 501 cannot be
selected.)
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-1 in 500 cannot be
selected.)
This selects whether to output the VITC data to the positions
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
This selects the signal to be regenerated when the time code
generator (TCG) in the REGEN mode.
0: Both the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This selects whether values used in the internal time code
generator are preset from the front panel or remote controller
or synchronized with time code values read from the tape.
0: Values are preset from the front panel or remote controller.
(PRESET)
1: Values are synchronized with time code values read from
the tape. (REGEN)
<Note>
When “1” is selected, values selected at set up menu No. 503
(TCG REGEN) are regenerated.
This selects the time code to be used when an external time
code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
This sets the usage status of the user bit of the time code
generated by the TCG.
0: NOT SPECIFIED (character set not specified)
1: ISO CHARACTER (8 bits character set based on ISO646,
ISO2022)
2: UNASSIGNED 1 (undefined)
3: UNASSIGNED 2 (undefined)
4: UNASSIGNED 3 (undefined)
5: PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
This selects whether to control the phase correction of the
LTC generated by the TCG.
0: Phase correction control is not performed.
1: Phase correction control is performed.
This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
1: CF flag is ON.