Filter
Top Products
28
Setup menus
USER menu
<EDIT> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
313 AFTER 0000 STOP
CUE-UP 0001 STILL1
0002 STILL2
315 AUD MEM 0000 OFF
UNIT 0001 MODE1
0002 MODE2
0003 MODE3
316 VAR STEP 0000 FINE
0001 COARSE
317 VAR FWD 0000 +4.1
MAX 0001 +1.85
0002 +1
318 VAR REV 0000 –4.1
MAX 0001 –1.85
0002 –1
0003 –0.43
319 JOG STEP 0000 FINE
0001 COARSE
The underline on the setting item denotes the initial setting.
This selects the mode after cue-up operation is complete.
0: STOP mode
1: SHTL STILL mode
2: VAR STILL mode
This selects the connection with the AJ-YA752 audio memory
unit.
0: When the audio memory unit is not going to be used
1: When a voice-over operation is to be conducted
2: When audio cross channel editing is to be performed for
CH2
3: When audio cross channel editing is to be performed for
CH1
<Notes>
• The RS-232C interface will function only when this menu
item is set to 0 (OFF).
• Refer to the Instruction Manual of the AJ-YA752 audio
memory unit for details on how the modes are used.
This selects the VAR speed during remote control operations.
0: The tape is played at the fine step speed.
1: The tape is played at a speed at which noise-less playback
is possible in the –0.43× to +1× (–0.5× to +1×) range.
<Notes>
• The speeds in parentheses apply when a DV or DVCAM
cassette is used.
• At the 1(COARSE) setting, the phase cannot be synchro-
nized from the editing controller.
This sets the maximum VAR FWD speed.
0: +4.1× (+3.1×) speed
1: +1.85× (+1.85×) speed
2: +1× (+1×) speed
<Notes>
• The speeds in parentheses apply when a DV or DVCAM
cassette is used.
• At any speed setting other than 0 (+4.1×), the phase cannot
be synchronized from the editing controller.
This sets the maximum VAR REV speed.
0: –4.1× (–3.1×) speed
1: –1.85× (–1.85×) speed
2: –1× (–1×) speed
3: –0.43× (–0.5×) speed
<Note>
The speeds in parentheses apply when a DV or DVCAM
cassette is used.
This selects the JOG speed during remote control operations.
0: The tape is played at the fine step speed.
1: The tape is played at a speed at which noise-less playback
is possible in the –0.43× to +1× (–0.5× to +1×) range.
<Notes>
• The speeds in parentheses apply when a DV or DVCAM
cassette is used.
• At the 1(COARSE) setting, the phase cannot be synchro-
nized from an editing controller which synchronizes the
phase using the JOG command.