Filter
Top Products
46
Error messages
Displaying the “HOURS METER” information
Press the cursor buttons ( , ) to move the cursor (
∗
).
The number for the item where the cursor is located is shown on the counter display.
Item No. Item Description
H00 OPERATION
H01 DRUM RUN
H02 TAPE RUN
H03 THREADING
H11 DRUM RUN r
H12 TAPE RUN r
H13 THREADING r
H30 POWER ON
<Note>
The resettable items in the “HOURS METER” information are reset by the service personnel when performing
maintenance or other work.
If T&S&M is selected in the setup menu No. 003 (DISPLAY SEL), a message appears in the mode display
whenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed.
Counter display and
Priority
monitor display
Description
High
Error messages
(See error message table)
INT SG
NO INPUT
Warning messages
(See warning message
Low
table)
Displays the time that the power has been supplied in one-hour units.
Displays the time that the drum has been rotating in one-hour units.
Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
one-hour units.
Displays the number of times for threading/unthreading in single units.
Displays the time that the drum has been rotating in one-hour units. (Can be reset)
Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
one-hour units. (Can be reset)
Displays the number of times for threading/unthreading in single units. (Can be reset)
This displays the number of power-on times with one power-on counting as one time.
When an abnormal operation is detected in this machine, an error number flashes
on the counter display and an error message is displayed.
If “BB” or “CB” in No. 601 (INT SG) in the setup menu is selected, pressing the REC
button (E to E mode) will display “INT SG” for the first two seconds. This is also
displayed for the first two seconds when starting editing from the external controller.
If there is no input signal (except for analog audio) to the connector selected using
the VIDEO INPUT switch, pressing the REC button (E to E mode) will display “NO
INPUT” for the first two seconds. This is also displayed for the first two seconds
when starting editing from the external controller.
When a warning occurs in this unit, an error number appears at the counter display
and warning message is displayed. When multiple warnings occur, the warning with
the highest priority is displayed.