Filter
Top Products
51
Specifications
GENERAL
Power supply: AC 120 V, 50 – 60 Hz
Power consumption: 95 W
Operating ambient temperature
:
Operating ambient humidity:
Weight:
Dimensions (W × H × D):
Recording format:
Recording video signals:
Recording audio signals:
Recording tracks:
Tape speed:
Recording time:
Tape:
FF/REW time:
Editing accuracy:
Tape timer accuracy:
Servo lock time:
VIDEO
(Digital video)
Sampling frequencies:
Quantizing:
Video compression system:
Video compression ratio:
Error correction:
Video recording/playback bit
rate:
Samples × number of effective
lines:
(Digital IN/Analog component OUT)
Video bandwidth:
S/N ratio:
K factor:
(Analog component IN/Analog component OUT)
Video bandwidth:
S/N ratio:
K factor:
(Analog composite IN/Analog composite OUT)
Video bandwidth:
DG:
DP:
Y/C delay:
K factor:
S/N ratio:
(Video input connector)
Analog component input:
Analog composite input:
S1 VIDEO input:
Reference input:
Serial digital component input
(option):
(Video output connector)
Analog component output:
Analog composite output:
S1 VIDEO output:
Serial digital component output
(option):
(Video output signals adjustment)
Video gain:
Chroma gain:
Hue:
Setup:
Sync phase:
SC phase:
AUDIO
(Digital audio)
Sampling frequencies:
Quantizing:
Frequency response:
Dynamic range:
Distortion:
Crosstalk:
Wow & flutter:
Headroom:
De-emphasis:
(Audio input connector)
Analog input (CH1/CH2):
Digital input (CH1/CH2)
:
Serial digital input
(option)
:
(Audio output connector)
Analog output (CH1/CH2):
Digital output (CH1/CH2):
Serial digital output (option):
Monitor output:
Headphones:
Other input/output connector
Time code input:
Time code output:
RS-422A input/output:
RS-232C:
Encoder remote:
Digital video interface input/
output (option):
Weight and dimensions when shown are approximately.
Specifications are subject to change without notice.
BNC×3 (Y, P
B, PR)
Y; 1.0 Vp-p, 75Ω
P
B, PR; 0.486/0.7 Vp-p switchable, 75Ω
(75% color bar, 7.5% setup)
BNC×3
Video1/video2/video3 (superimpose
on/off)
S terminal (4-pin)×1
Y; 1.0 Vp-p, 75Ω
C; 0.286 Vp-p (burst), 75Ω
Complies with SMPTE259M-C standard,
BNC×3
±3 dB
±3 dB
±30°
±14 IRE
±15 µs
±180°
48 kHz (synchronized with video signal)
16 bits
20 Hz to 20 kHz (±1.0 dB) (at reference
level)
Better than 85 dB (1 kHz, emphasis OFF,
“A” weighted)
Less than 0.1% (1 kHz, emphasis OFF,
standard level)
Less than –80 dB (1 kHz, between
2 channels)
Below measurable limits
20 dB
T1=50 µs/T2=15 µs (on/off automatic)
XLR×2, 600Ω/high impedance selectable,
+4/0/–20/–60 dBu
BNC×1, AES/EBU format
Complies with SMPTE259M-C, 272M-A
standard (BNC, 75Ω)
XLR×2, low impedance, +4/0/–20 dBu
BNC×1, AES/EBU format
Complies with SMPTE259M-C, 272M-A
standard (BNC, 75Ω)
Phono×1, 600Ω, –8 dBV
Variable level, 1/4" phone, 8Ω
BNC×1, 0.5 Vp-p to 8 Vp-p, 10 kΩ
BNC×1, 2.0 Vp-p ±0.5 Vp-p,
low impedance
D-sub 9-pin, RS-422A interface
D-sub 25-pin, RS-232C interface
D-sub 15-pin
Compliant with IEEE1394-1995 standard,
6 pins × 1
41°F to 104°F (5°C to 40°C)
10% to 90% (no condensation)
31.46 lbs (14.3 kg)
16-3/4 × 6-15/16 ×16-3/8 inches
(424 × 175.2 × 415 mm)
DVCPRO format/DV format
525i
48 kHz, 16 bits, 2 channels (DVCPRO)
Digital video/audio helical track
Time code; Recorded in sub-code area
Digital audio; 2 channels
Cue Track; 1 track
Control (CTL); 1 track
33.820 mm/sec
126 minutes (with AJ-P126LP)
66 minutes (with AJ-P66MP)
1/4-inch thin magnetic layer metal tape
Less than 3 min (with AJ-P126LP)
Less than 2 min (with AJ-P66MP)
±0 frame (using time code)
±1 frame (using continuous CTL signal)
Less than 0.5 sec. (color framing/
standby ON)
Y; 13.5 MHz/P
B, PR; 3.375 MHz
8 bits
DV-based compression (SMPTE314M)
1/5 (DVCPRO)
Reed-Solomon product code
25 Mbps (DVCPRO)
720 × 480/frame (DVCPRO)
Y; 30 Hz to 5.5 MHz (±1.0 dB)
P
B, PR; 30 Hz to 1.3 MHz (±1.0 dB)
Better than 56 dB
Less than 2%
Y; 30 Hz to 5.5 MHz (–1.5 dB to +1.0 dB)
P
B, PR; 30 Hz to 1.3 MHz
(–2.0 dB to +1.0 dB)
Better than 55 dB
Less than 2%
Y; 30 Hz to 4.5 MHz (–1.5 dB to +1.0 dB)
Less than 4%
Less than 3°
Better than 20 ns
Less than 3%
Better than 48 dB
BNC×3 (Y, P
B, PR)
Y; 1.0 Vp-p, 75Ω
P
B, PR; 0.486/0.7 Vp-p switchable, 75Ω
(75% color bar, 7.5% setup)
BNC×2, loop-through, 75Ω on/off
S terminal (4-pin)×1
Y; 1.0 Vp-p, 75Ω
C; 0.286 Vp-p (burst), 75Ω
Analog composite
BNC×2, loop-through, 75Ω on/off
Complies with SMPTE259M-C standard,
BNC×2, active through