Filter
Top Products
33
USER menu
<VIDEO>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
600 PB/PR 0000 MII
IN LV 0001 B-CAM
601 INT SG 0000 OFF
0001 BB
0002 CB
602 INPUT 0000 B/W
C KILL
0001 AUTO
603 OUT 0000 N-VF
VSYNC 0001 VF
604 V-MUTE 0000 N-MUTE
SEL
0001 LOW
_
RF
605 CC (F1) 0000 BLANK
BLANK
0001 THRU
606 CC (F2) 0000 BLANK
BLANK
0001 THRU
608 FREEZE 0000 FIELD
SEL 0001 FRAME
611 EDH 0000 OFF
0001 ON
The underline on the setting item denotes the initial setting.
This selects the component input signal level.
0: MII level.
1: ß cam level.
For selecting whether an internal signal is to be generated.
0: No signal is generated.
1: A black burst signal is generated.
2: A 100% color bar signal is generated.
<Notes>
• The INT SG message appears for 2 seconds when recording
commences.
• If the VIDEO INPUT switch #3 is set to DVCPRO/DV, the
audio signals will also serve automatically as the internal
signals when a video signal has been selected as the
internal signal by this menu item setting.
This selects color killer processing for the video input signals.
0: The signals are forcibly processed as B/W signals.
1: The signals are automatically processed.
This selects whether to float the vertical sync position of the
video output in order to align the video output phase with the
input in the EE/record/edit modes.
0: Signals are not floated.
1: Signals are floated.
This selects whether the video output signal is to be muted
when the blank portion of the tape is detected during playback.
0: No muting
1: Muting (picture turns grey).
This selects ON or OFF for the closed caption signal in the
first field.
0: Forced blanking performed.
1: Blanking not performed.
This selects ON or OFF for the closed caption signal in the
second field.
0: Forced blanking performed.
1: Blanking not performed.
For selecting how the still picture is to be output.
0: Field output
1: Frame output
<Note>
When frame output is selected, the frame slow mode will be
established during slow motion as well.
This selects whether to superimpose EDH onto the serial
output signals.
0: EDH is not superimposed.
1: EDH is superimposed.
<Notes>
• This display will not appear unless the AJ-YA455P serial
interface board (optional accessory) has been installed.
• Even when 1 (ON) has been selected, EDH is not super-
imposed at the SERIAL OUT 3 connector if the SUPER ON/
OFF switch is at the ON position.