Filter
Top Products
23
RQTV0141
Connection (without Audio/Video cable) only
In some cases, interference (lines or patterning) or a very poor
picture may appear on the TV when the DVD Recorder is
connected. If this happens, follow the steps below to change
the video playback channel (RF output channel) to remove the
interference.
[1] Press [FUNCTIONS] for
more than 5 seconds.
The RF output channel number is
displayed on the unit display.
[2] Press [CH,W, X] to
select a channel number
(CH3 or CH4).
The unit’s display
Each time you press the button:
CH 3 (Default setting) (# CH4 (# OFF
^-----------------------------------------------J
≥Set the RF output channel of the DVD Video Recorder to
“OFF” (RF OFF) when the DVD Video Recorder is connected
to the TV via the Audio/Video cable.
[3] Press [ENTER] to finish this setting.
Removing Interference
∫When you set the RF output channel to “CH3” or
“CH4”
A picture is output on CH3 or CH4 from RF output.
Press [VCR/TV] to switch the mode from TV to VCR, and vice
versa.
≥When the TV mode is selected, the “TV” indicator lights on the
unit’s display and you can watch TV.
≥When the “TV” indicator does not light on, then VCR mode is
selected and you can watch images from the unit.