Panasonic PT-DZ21KE Home Theater Screen User Manual


 
Maintenance/replacement
150 - ENGLISH
Maintenance
6) Attach the lamp case.
z
Gently push in the lamp case along the grooves for the lamp case attachment guide on the projector, and
then rmly tighten the lamp case xing screws (two screws).
z
When you secure the lamp case with the projector installed upward in the vertical direction, the lamp case
may drop off on its weight. Be sure to hold the lamp case handle when you tighten the lamp case xing
screws.
z
If the lamp case is not installed properly, remove it and then gently install it again. Pushing it in forcibly or
exerting excessive force may break the connector.
z
Make sure to attach the lamp case properly.
Grooves of the guide to attach the lamp case
Guides to attach the lamp case
Lamp case handles
Lamp case L
Lamp case R
Lamp case fixing screws
7) Attach the lamp unit cover.
(i) Align the lamp unit cover to the marks of (a) and (b) ( and ) to attach as shown by the arrow.
(ii) Close the lamp unit cover in the direction of the arrow and use a Phillips screw driver to rmly tighten
the lamp unit cover xing screw (one screw).
z
Make sure to attach the lamp unit cover properly.
D
E
L
LL
Note
z
When you place the new lamp unit, the projector resets the total usage time of the lamp unit automatically.
z
When the lamp case is removed or attached, it will be caught because of the fall-prevention stopper. This,
however, is not a problem.