Filter
Top Products
[3D SETTINGS] menu (PT-DZ21KE and PT-DS20KE only)
ENGLISH - 83
Settings
z
Items set in [3D SYNC2]
[OFF] Not used.
[1] Stereo synch output
[2] 3D trigger output
[3] Through 3D SYNC1
[4] Stereo synch output
[5] 3D trigger output
[6] Through 3D SYNC1
[7] Stereo synch output
[8] 3D trigger output
[9] Frame synch output
[10] Frame synch output
[11] 3D IR TRANSMITTER (–) output
6) If you selected [1], [4], [7], or [10],
press
to select [STEREO SYNC
OUTPUT DELAY] and press
to set
the amount of delay output.
z
Values in the following range change by units of
10 us.
0 us to 25 000 us
z
To synchronize multiple projectors to display 3D
images, use a frame synch input and output.
Select [9] or [10] for the rst projector.
Select [6], [7], or [8] for the second and
subsequent projectors.
z
Stereo synch is a Duty 50% signal at High
during Left and at Low during Right.
z
An “H” is output to the 3D images display and
an “L” is output to the 2D image display from
the terminal for which 3D trigger output is
selected.
Note
z
[11] of [3D SYNC SETTING] is the setting when
the 3D IR Transmitter TY-3DTRW (Panasonic) is
used with this projector. As for connecting method,
consult your dealer.
[3D SIMUL INPUT SETTING]
Set to input and use simultaneous 3D images signals.
1) Press
to select [3D SIMUL INPUT
SETTING].
2) Press the <ENTER> button.
z
The [3D SIMUL INPUT SETTING] screen is
displayed.
3) Press
to select [LEFT:RGB1
RIGHT:RGB2], [LEFT:HDMI
RIGHT:DVI-D], or [LEFT:SDI1
RIGHT:SDI2].
4) Press
to switch the setting.
z
The setting will change as follows each time
you press the button.
[OFF] [AUTO]
[OFF] Cannot use 3D simultaneous.
[AUTO] Displays simultaneous 3D images.
Note
z
When set to [AUTO], 3D images are displayed
when the same 3D compatible signals are entered
to each input. However, the P IN P status during P
IN P is maintained.
z
This may not function properly for some external
devices that are connected.
z
Certain signals may not function properly.