Filter
Top Products
Switching on/off the projector
ENGLISH - 51
Basic Operation
Switching off the projector
1) Press the power standby < > button.
2) Press
to select [OK], and press
the <ENTER> button.
(Or press the power standby <
>
button again)
z
Projection of the image will stop, and the power
indicator <ON (G)/STANDBY (R)> on the
projector lights in orange.
(The fan keeps running.)
3) Wait until the power indicator <ON
(G)/STANDBY (R)> of the projector
lights in red (and the fan stops) for
approximately 170 seconds.
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the power.
Note
z
Do not turn on the power and project images
immediately after turning the projector off.
Turning on the power while the lamp is still hot may
shorten the lamp life.
z
In about 75 seconds after the projector is switched
off and the luminous lamp cooling is started, the
lamp indicators will not light up even if the power is
switched on. Even after 75 seconds, the lamp may
not light up if the power is switched on. After the
power indicator <ON (G)/STANDBY (R)> lights in
red, turn on the power again.
z
The projector consumes power even when the
power standby <
> button is pressed and the
power is switched off if the projector’s main
power is on.
Refer to “Power consumption” (
page 172) for the
power consumption.
1)
1)
3)
2)
2)
4)