Filter
Top Products
C2629M-A (6/07) 35
DHCP SETUP
Your network must support DHCP, and an active DHCP server must be present for dynamic addressing to work. Consult your network
administrator for more information.
To configure the DVR to acquire a dynamic IP address through DHCP:
1. Click .
2. Click . The Network page is displayed.
3. Click the check box labeled Obtain An IP Address Automatically (DHCP).
4. Click Apply.
Figure 30. DHCP Setup
STATIC IP SETUP
To set up a static IP address, enter the following information in the fields provided. This information can be obtained from your network
administrator.
1. Verify that the Obtain An IP Address Automatically (DHCP) check box is not selected.
2. Enter a unique IP address (for example, 10.0.0.101). The last three digits must be different for each recorder (for example, 101, 102, 103,
and so forth).
3. Enter the subnet mask (for example, 255.0.0.0).
4. Enter the default gateway address (the IP address of the default router on your immediate network segment).
5. Click Apply.
Figure 31. Static IP Setup