Filter
Top Products
26 On cmen StatusDisplays
A statusdisplaywill appearwhenyou pressthe STATUS/EXITbut-
ton or certainfunctionbuttons.Thecontentsof the statusdisplay
will vary.Tochoosethe statusdisplaymode, followthe steps
below.
If you select STATUS ON, then select COUNTER ONLY
OFF:
• Whenever you pressthe STOP/Y button or the PLAYIA but-
ton, the statusdisplaywill appearfor five seconds.
If you select STATUS ON, then select COUNTER ONLY
ON:
• Whenever you pressthe PLAYIA button,the statusdisplaywill
appearfor fiveseconds.Afterfiveseconds,onlythe counterwill
remain on-screen.
If you select STATUS OFF:
• The statusdisplaywill not appearwhen you pressfunction but-
tons.You mustpressthe STATUS/EXITbutton to seethe status
display.
I
Press the MENU button.
Function
Channel Button
Time Pressed
Jo1
AMcHI0 S
SLP M 1:23:45
_J I
I I
Tape Counter
Speed and
Counter
Memory
2
Press the PLAYIA, button or the STOPIY button to select
VCR SETUP, then press the F.FWDII_ button.
3
Press the PLAYI& button or the STOPIY button to select
ON-SCREEN MODE, then press the F.FWD/I_ button.
4
Press the PL&YI& button or the STOPIY button to select
STATUS, then press the F.FWDII_ button so that ON or
OFF appears beside STATUS.
STATUS [O
SELECT AV CHOOSE IP
END PRESSr_(IT
5
If you set STATUS to OFF, go to step 6. If you set STATUS
to ON, press the PLAY/& button or the STOP/V button
to select COUNTER ONLY, then pressthe F.FWD/I_ but-
ton so that ON or OFF appears beside it.
6
Press the STATUSIEXIT button.
i" if the channel youselecthas no
bmedcas_the screenwill be solid
blue.
You cannotview closedcap_onsdur-
_ngrecording or tape playback if
COUNTER ONLY isset to ON.
Details are on pages 38 - 39.