Filter
Top Products
28
9.10 ALTERING MODEM SETTINGS
You may need to alter the settings within this menu when you connect your digital receiver to a
telephone line. Press the MENU button, followed by number button 4 (viewing preferences) then
3 for modem settings.
MODEM
This option enables you to tell the receiver if you are using the internal modem or have added an
external modem.
DIALLING
This option is to choose either tone or pulse dialling. Most domestic telephones use tone dialling.
If you are unsure, check with your telephone company.
CONNECTION
You will only need to change this setting to pabx if your digital receiver is connected to a phone
line that requires you to dial a prefix for an outside line. Most domestic telephones will operate
with a direct connection.
PREFIX
This option is only available If you have chosen pabx in the connection option. You can then
choose the prefix that the digital receiver will dial in order to get an outside line.
WAIT FOR DIAL TONE
This option is only available if you have chosen pabx in the connection option. You can then
adjust this setting depending on what your system requires.
STD CODE
This allows you to tell the receiver whether it will always be required to dial an STD code.
PREFIX
If you have selected to choose an STD code, this allows you to enter the code using the
NUMBER buttons.
9.11 TECHNICAL INFORMATION
The options contained within the technical information menu enable you to check the status of
your digital receiver. This is not something you should need to do, apart from in the unlikely
event of a problem occurring with your receiver. In this instance, it will help the ONdigital
customer services people to understand the problem and resolve it as quickly as possible.
There are 3 options from the menu, signal strength, manufacturer data and auto update.
SIGNAL STRENGTH
This section will help to determine the strength of signal that is available to your digital receiver.
The display details the output channel that has been selected and the signal strength of that
channel.
To enter the UHF number, press the GREEN button, enter the channel number and press the
RED button to measure the signal strength.
You will not normally need to refer to this screen, but should you have any reception problems, it
maybe referred to during a call to the ONdigital customer services.