Filter
Top Products
30
IF YOUR DIGITAL RECEIVER ’S REMOTE
INTERFERES WITH YOUR TELEVISION.
If you have interference between your digital receiver’s remote control and your particular brand
of television set, it may be because the television incorrectly responds to infra-red commands not
intended for it.
Your digital receiver and remote can work with one of two infra-red coding systems A & B. The
normal setting for your receiver and remote control is system A, these can however be changed
to system
B
, to avoid conflict with your television set.
10.1 To change your digital receiver from system
A to system B.
1. Ensure your digital receiver is switched off (if necessary press the ON/OFF button)
2. Press the ON/OFF button to switch on your digital receiver (the front display shows the time
or “—:—”), your digital receiver will now be in standby.
3. Press and hold the M button on the front panel of your digital receiver for at least 3 seconds.
4. The front control panel of the digital receiver will now show “-SA-” (this stands for system A).
5. Press the B (right arrow) button to change the display from “-SA-” to “-Sb-”.
6. Press the S button to store the displayed setting, your digital receiver returns to standby and
is now programmed to use system B.
Note:
During the above process, if there is a time lapse of more than 10 seconds between
key presses the digital receiver will return to standby.
Should you at any time wish to change your digital receiver back to system A commands, exactly
the same sequence should be used except this time the B (right arrow) button is used to change
the display to “-SA-”.
10.2 To change your remote control from system
A to system B.
1. Locate the B (standby) and TEXT buttons on your remote control.
2. Simultaneously press and hold these two buttons for at least 3 seconds.
3. After releasing the B (standby) and TEXT buttons use the number buttons on the remote
to enter the three digit code 161.
Your remote is now programmed to work with system B commands.
Note:
Should you at any time wish to change your remote control back, to work with system
A commands, exactly the same sequence should be used except this time the code
entered should be 160.
Important:
If your remote is not powered for more than one minute, for instance when the batteries are
changed, it is possible your remote could revert back to system A and no longer works your
digital receiver.
Should this happen, please carry out the steps shown above to change the remote back to
system B
.
TV or Video settings you may have entered to operate products other than Philips will also be
lost. Refer to chapter 11 “Programming the remote for your TV and Video” for information about
these settings.
10
10